The model file is downloaded on MyMiniFactory with your account — that's how their catalog works. Download it and attach it to your order: the studio will print it and quote a price.
The creator allows printing this model for personal use only: prints can't be sold. The studio will print it for you personally.
Creator's license: Creative Commons - Attribution - Noncommercial - ShareAlike
Creator's description
1. Print without supports. Support only for screw slots, only on the table. I do not recommend supports in part number 1. Support only in parts where there are through holes.2. I printed the prototype from PETG.3. I tested the prototype for a long time with high-power LEDs installed and a 12VDC 25W power supply.4. The lamp heats up in some places to about 48 degrees Celsius. This is normal. The power supply can heat up to 51 - 54 degrees, but in inaccessible places. I did not find any problems related to temperature during tests.5. The LED cover on the base expands slightly and becomes loose when heated. This does not affect the operation of the lamp and is not a problem, just an unforeseen inconvenience.6. LED covers can be printed from transparent materials. In the prototype I made it from white opaque PETG and the lamp shines well. In this version it serves as a night light. If we use transparent materials the lamp will shine brighter.7. To reduce the lamp's heating, you can use a lower-power LED and a lower-power power supply. Here you can adjust the parts yourself.8. I used a typical power supply mounted in electrical installation boxes. I used a waterproof power supply with a height of 22 mm but you can go up to 24 mm and a diameter of 50 mm but you can go up to 52 mm.9. To connect the installation inside the lamp, I used WAGO single-line connectors - 4 pieces, crimped with the possibility of disconnection. I provided a place for such connectors during the design.10. The wires to the LED strips must be soldered.11. The LED strip in the round part is 375 mm long and is mounted tightly so that there is no gap and no visible change in light. I recommend LED strips that can be cut every 25 mm.12. The LED strip in the base is 312.5 mm long and has a slot. The slot makes it easier to mount and is located on the back of the lamp.13. I used a ready-made power cable with a switch, commercially available, 3 m long – with a cross-section of 2X0.75 mm square and a maximum current of 2.5 A.14. To protect the power cord from being pulled out, I pushed it in deeper and hid it around the power supply. There is no way to pull the cord out and the switch is closer to the lamp, which is beneficial.15. The lamp has no small or detachable parts, so it is safe for children.16. The lamp is not waterproof but has a higher level of water resistance.17. Elements 4 can be glued with glue or double-sided adhesive tape.18. Element 9 should be glued to element 10 using glue. Remember the order of assembly. I recommend transparent glue PATTEX – ONE FOR ALL (CRYSTAL). PL LAMPA – STOJAK DLA SŁUCHAWEK 1. Drukować bez podpór. Podpory jedynie dla wpustów pod wkręty, tylko na stole. Nie zalecam podpór w części numer 1. Podpory tylko w częściach gdzie są otwory przelotowe.2. Prototyp wydrukowałem z PETG.3. Prototyp testowałem długotrwale z zamontowanymi LED o dużej mocy i zasilaczem 12VDC o mocy 25W.4. Lampa się nagrzewa w niektórych miejscach do około 48 stopni Celsjusza